Manure Manager

News
H & S spreader features


April 3, 2008
By H & S Manufacturing

The H & S 1502 manure spreader
with an 1,502-gallon capacity from H & S Manufacturing features a
V-tank that is mounted on a full length, all-welded unitized frame.

The H & S 1502 manure spreader with an 1,502-gallon capacity from H & S Manufacturing features a V-tank that is mounted on a full length, all-welded unitized frame. The large frame is constructed of structural steel U-channel and reinforced at all stress points. The one piece Clevis hitch is lined with hardened wear plates. Hubs, spindles and walking beam assemblies are load rated.

    Overbuilt construction on the 1502 is said to ensure dependable service.
    Dual 18” diameter augers are equipped with wipers and hold downs. The solid flight augers carry the load rather than undercutting. This feature—along with steep sloped sides—is said to virtually eliminate manure hang-up and bridging.

    The shredder beater turns up to 300 rpm and is equipped with hardened replaceable teeth, said to be effective in shredding hard pack and tough manure. It also undercuts heaped loads, forcing manure downward and through the rear endgate to the expeller beater.

    When the endgate is fully opened, the rear opening is 42” wide and 30” high.         The endgate is a full 1/2” thick and reinforced at stress points. When closed, the rear gate seals tightly, eliminating fluid leakage, the company says. The endgate track and seals are poly lined to prevent freeze up.

www.hsmfg.com


Print this page

Related



Leave a Reply

Your email address will not be published. Required fields are marked *

*